OK, so i got a new MP5 and loaded the 220 software which was asked for based on key. Eveything loaded just fine and it reset itself. Now, however, i cannot login via VMMI or hyperterm.

I have verified my VMMI version as 220 and am using the same cable used to load software.

Anyone have any troubles logging into an MP5 after 220 load?

Serial connection or TCP/IP? Have you tried dip switch 1, to set the baud rate for serial connection?

You're not referring to not being able to get in right after the system reset, right? You waited a while and still can't get in?

Justin

Sorry, vegged on setting DIP 8 to on during the power up.

Thats what i get for now working on these for a long time! (3 1/2 years ago was the last when).

Oh yeah, that too (dip switch 8). Glad to hear you got it going.

Justin