atcomsystems.ca/forum
Posted By: Beginner VOIP - 05/28/05 11:06 PM
Ok..
I am New in the VOIP World.
I have an Samsung IDCS500 release2 PBX With MGI2 Card and i want to perform a call to to a PC with netmeeting using WAN.
1) to connect my PBX to the internet I connect it to My LAN which has a PC Connected to the Internet;This PC represent the Gateway...(Is it True?)
2) on The PBX (Is It OK?!)
MMC 830-->
MCP2: Private IP 192.168.0.22(Like my LAN)
Public IP = 80.90.130.30(Like the other peer IP)
GW 192.168.0.11 (The connected PC )
Use Private & Public
MMC 831-->
MGI: Private IP 192.168.0.33
Public IP = 80.90.130.35
GW 192.168.0.11
Use Private & Public
MMC 832--> To Dial Table 00
MMc 833--> 80.90.130.30 on Table 00

I appreciate any help.....Thanks
Posted By: pvj Re: VOIP - 05/29/05 11:17 AM
The mgi card needs a static public ip address make sure you have that.
Posted By: Beginner Re: VOIP - 05/29/05 10:47 PM
OK I have one, but about my procedure and programing is it true?
Posted By: Wkstill Re: VOIP - 06/02/05 12:08 PM
I don't think you can use NetMeeting for any communications for SamSung
Posted By: Beginner Re: VOIP - 06/04/05 11:03 PM
No...You can netmeet it, I am using it in my LAN and is working verry well .... But within WAN.. unfortunately I could not do any thing yet.
Posted By: mathrap Re: VOIP - 09/24/05 05:16 PM
Yaa ??? If you can netmeet it , you'r the new Samsung IT gay.Don't STOOP ....
Posted By: WRichey Re: VOIP - 09/26/05 06:58 AM
Ahmed

check mmc 834 and open port 10000 netmeeting uses h.323 and 10000 is the common port for this communication. If it works on the lan then the wan is no different its just a matter of port routing. these are the ports netmeeting uses Pass through primary TCP connections on ports 522, 389, 1503, 1720 and 1731.
Pass through secondary UDP connections on dynamically assigned ports (1024-65535

make sure your router is set up accordingly
Posted By: chrislebeck Re: VOIP - 09/26/05 04:40 PM
Ahmed Kamal>>i'd be interested in your setup using netmeeting to connect to our 500. the voip is already set and working.
© Sundance Phone System Forums - VOIP & Cloud Phone Help