Hey fellas,

I am in the process of installing a refurbished DCS 100 I have an expansion cabinet with 2 trunk cards one in slot 1 and one in slot 2

In the main cabinet I have DLI cards in slots 1-4. Slots 1-2-3 have working ports but no Ext numbers are auto populating.

In slot 4 the Extension numbers are coming up 201 - 208.

My trunks are coming up in programming as
trunk = 225 226 227 228 229 230 231 232
trunk = 233 234 235 236 237 238 239 240

I tried to default the system with MMC811 but it only gives me the option to do a System Reset. Come to think of it Im not certain that I tried to arrow up and see if RESET Memory becomes an option. I will be back out there tomorrow. Any input here is appreciated, thanks to all and have a great weekend.

THE
FLDiver!!!

mmc 811 has 2 options. System reset and clear memory. You must choose clear memory. This clears all memory except country code.

And IP address

If you turn off the memory switch and power down, that will do the same thing as MMC811, but of course you have to turn the memory switch back on after power up.

It is a little on/off switch on the side of the MEM card.

Your Trunks start at 701 and go up.

You have eight extensions on the base cabinet 201 to 208 an NO trunks on the base cabinet unless there are cards plugged into the three slots.

Far left slot = possible 2 single line card
Next = Memory card
Next = Possible Misc. card
Next 3 = Trunk or Station or 2 Trunk/4 station card