Was finally able to start reprogramming MCP1 bd. Most MMC's went OK,however MMC304's(assign station/trunk) number designation did not match the other MMC's. All other MMC's refer to the trunks as 700's and stations as 200's. MMC304 refers to the trunks as 101,102 etc. and the stations as 1,2,3 etc. I'm trying to get some phones to not be able to dial out and this went just fine when we had a MEM3 bd.
Thanks,
Creig

You need to build trunk groups and station groups in MMC 6XX then assign what groups can use what groups in MMC 304.

you need to assign the station and trunks to use groups in 614 and then it will all make sense.