Greetings,
Has anyone ever connected the page port from a 7400 to a Bogen PCM 2000? Right now we use a loop start trunk into it but the client would like to page digital sets along with the overhead zone or zones as the case may be. Could this work?
Thanks

Install a Valcom Analog Paging Adapter.
Alot easier. I think its a V-9940

If you're looking at the manual for the pcm2000. You need to use setup configuration 2. This will allow you to use the page port from the system. https://www.bogen.com/products/pdfs/telephonepagepdfs/PCM200c.pdf