Replacing 62.5/125 with 50 MicronOM3 - 05/06/17 03:09 PM
I have a customer who wants to replace (4) Separate fibers runs
with 50 Micron OM3
(2) of the runs are from building to building with conduit
(1) building has a piece of inner duct inside a 4 inch conduit with a exiting fiber in there already my question is this
should I or can I try to send a snake in the inner duct and pull a piece of new fiber in the inner duct I was thinking indoor/outdoor or should I try to pull a piece of outdoor armored just in the conduit there looks like theres plenty of room The inner duct looks like its a 1.25 wide
I know I could probably use the exiting piece of fiber for a pull but I would prefer to leave that in place to prevent any down time
it is a school and the work will be done in summer
The other run is just a 4 inch conduit which I pulled the exiting cable a while back
so I was just going to use the outside Armored for that
Any Thoughts would be greatly appreciated
Thanks!!
with 50 Micron OM3
(2) of the runs are from building to building with conduit
(1) building has a piece of inner duct inside a 4 inch conduit with a exiting fiber in there already my question is this
should I or can I try to send a snake in the inner duct and pull a piece of new fiber in the inner duct I was thinking indoor/outdoor or should I try to pull a piece of outdoor armored just in the conduit there looks like theres plenty of room The inner duct looks like its a 1.25 wide
I know I could probably use the exiting piece of fiber for a pull but I would prefer to leave that in place to prevent any down time
it is a school and the work will be done in summer
The other run is just a 4 inch conduit which I pulled the exiting cable a while back
so I was just going to use the outside Armored for that
Any Thoughts would be greatly appreciated
Thanks!!