I am using the latest version of VIP and I have noticed that recently my station status indications stopped working in VIP. It is communicating properly with the cabinet because all other functionality is still working properly. The only change that has occurred recently is that the subnet mask of my network has changed. I am still using the same IP addresses as before but the subnet mask did change. Does anyone have any ideas of how to correct this? Thanks in advance.

Ok, I have corrected the problem. Evidently, even though I had changed the subnet mask setting on the NSP, it apparently had not taken full effect. I changed the NSP address to another valid address, waited 30 seconds and then changed it back and now when I open VIP everything is working normally again. Don't know if anyone else here will ever benefit from this, but I figured it is worth posting the results just in case.