NOTE: <Ctrl-P> Esc does the trick!

This is odd. I get the "status" display but when I hit ESC it repaints and usually displays idle: which disappears. I never get the password prompt.

Any ideas? I've reset, reseated boards (desperate measure), powered-down, etc.

Using Procomm at 9600-8-n-1 on same system i originally configured with!


[This message has been edited by gagop (edited August 30, 2004).]

Bad I/O port!
Sometimes the ports will transmit, but not recieve.
Is it a I/O expansion board on the CPU?

Your on an Operator port.Press Ctrl P and then you will get a prompt.

Great catch PVJ!!
I read past that.

Good Job,
JJ.

Sometimes I get lucky