I have an Executone 648 with an Inforstar VX connected. The inforstar VX is being replaced with a VX3. I am having a problem with the In-Band integration of the VX3. I followed the installation, setup, and integration note to connect the VX3 and double-checked the settings. The problem I am having is only the 1st four ports function. The remaining 20 ports will go off-hook then immediately on-hook, and finally back to waiting as observed from the Run screen. If all four ports are busy I get a busy tone until one of the first, four ports become available. I verified that the SLI stations are hunting through all 24 stations. The run screen shows all 24 ports in waiting status. The manual does not show the switch setting on the Infostar’s port cards so I cannot verify if those are set correctly. I take it that they are since the Run screen shows that they are in waiting status.

Thanks in advance.

Tony

Are you sure the dongle is a 24 port VXIII dongle? sounds like a 4 port unit.

If it is 24 port make sure you have all 24 ports programmed alike in the phone system and VXIII.

You also need to make sure that the port on the VXIII is programmed with the same exteinsion number that it is hooked to.
Example: port one in VXIII is programmed as ext 3901 and is hooked to ext 3901 on the phone system.

Good Luck!!

[This message has been edited by JJ (edited April 22, 2005).]