I had the output fuse on the GPS-6A power supply blow. What was in there was a 32 volt 10 amp buse fuse. Since this was a refurbed power supply I'm trying to find out if this is the correct fuse, I can't find the fuse size in the manual. Thanks
ok, just Help me a little, Name of the system ( I think there were a few different flavors of 3672
Encore CX is what my manual says.
I think it's the ENCORE CX 3672? Can't seem to find manual I had. So if nonameyet is unable to assist let me know. I have a friend that may still have his manual and list of fuses. It's the one with the DC to DC converter correct?
well, it looks like those couple of pages are GONE..all I have is some programming stuff, and I found a couple of pages of carrier codes for the IDS systems LCR...
sorry, I can't help.
Originally posted by mc601:
It's the one with the DC to DC converter correct?
No the main AC to DC power supply. I don't belive the DC to DC has fuses, but I could be wrong.
I just pulled the fuse on a couple GPS-6A supplies we have in the shop (original fuses, I believe). It's a 5A, 125V. I hope this helps.
Thanks for the information, I believe that is the input fuse. Correct? This has an input and output fuse, it's the output I'm trying to confirm.
Sorry. Apparently, not all GPS-6A supplies have an output fuse. Only one of the three we have in stock has the output fuse, which is labeled 10A, 125VAC. This is also an original fuse. I hope this is more helpful than my last post.
That certainly makes more sense than the 10A 32volt that was in this one, though it lasted a couple months before blowing. This one was labeled 125 volt, didn't have the amps, below the fuse socket, that's why I wanted to verify what it took. Thanks for checking.