I am having issues connecting to this system directly. I have Procomm set to Direct connect 9600 and I believe I have the cable wired correctly. I am getting only one screen about calls in progress but can't pull up the main config page. Nothing i press does anything but this screen. Is there anything else I need to do? This is a new cpu card so there is no programming on it yet. The cable I have only has 3 wires used. RJ45 pins 5, 6, and 4 go to db9 2,3,and 5 respectively.
what port are you plugged into? also, what emulation are you using? ( It's been a LONG time ago , the last time i messed with a " 84 " )
Sounds like you are on the Operator screen press Ctrl P to get to programming
Sounds like you are on the Operator screen press Ctrl P to get to programming
Thats exactly what I was thinking.....about 2 hours After I responded
That should have gotten you into program mode.
If you want to stop that in the future go to B-Screen system
programming and there is an setting to turn that from a Y to N
Have a good one. Glad to see there are still some systems out there
as they were good for sure.