atcomsystems.ca/forum
Posted By: RICHR Adding a Mailbox in DB 6.006 - 06/17/11 03:15 PM
I am trying to add a mailbox to my system. The instructions begin with Axxessory Talk-Devices-Mailboxes. I do not see Axxessory Talk on my DB screen.
I know I have done this before so it's there somewhere but it's been a very long time and I have searched every folder and can't find it.

Can anyone help me?

I still have a support contract on my system but they told me it would be 3-4 days before anyone would respond to my programming support request.

Thanks

RR
Posted By: Stix1 Re: Adding a Mailbox in DB 6.006 - 06/17/11 04:01 PM
Axxessory Talk = Voice Processor
Posted By: RICHR Re: Adding a Mailbox in DB 6.006 - 06/17/11 05:52 PM
Thanks for the quick response.
Voice Processor is also not present, at least in any obvious place.
I seem to recall that it was in the second level of the tree but it is now gone. Could I have delted it somehow? The Voicemail system is working fine.

RR
Posted By: DND ON Re: Adding a Mailbox in DB 6.006 - 06/17/11 06:46 PM
A few possibilities:

Does the password that you’re using allow access to Voice Processor?

Are you in local mode instead of remote?

Is the Voice Processor Enable box checked as NO?
Posted By: RICHR Re: Adding a Mailbox in DB 6.006 - 06/17/11 06:57 PM
No password but I did see the Voice Processor Enable box was set at NO. I am the only admin and I didn't change that but I thought that might be the problem. I was afraid to change it since I didn't change it to NO in the first place.

After thinking about it I went looking for it again and was going to get brave and switch it back to YES but I couldn't remember where I saw it.

RR
Posted By: RICHR Re: Adding a Mailbox in DB 6.006 - 06/17/11 08:02 PM
Found it, changed it, all is well.

Thanks for your help,

RR
© Sundance Phone System Forums - VOIP & Cloud Phone Help