I need to change the ip address on a unit I just got and need to know what terminal emulation and settings to get in and do that.
Thanks,
Dave

If it is new or has been defaulted, the IP will be 192.168.1.190, and you can change the IP via the web interface.

You'll need to set the PC communicating with the NBX to 192.168.1.191

If you must go in via serial connection (COM1 only), use:

Terminal emulation: VT100
Baud: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None


You'll now be at a bare VXWorks command prompt. If you are not familiar with VXWorks it will be far easier (and safer) to use a PC and switch to discover the current IP of your NBX100. I cannot stress that enough.