atcomsystems.ca/forum
Posted By: BT123 Merlin 2 line assignment - 06/27/11 08:08 AM
Hello all. I was sent to a customer with a merlin 2 system. I haven't worked on this system in years. I was able to figure out how to remove the lines from pool 9. But, I couldn't figure out how to assign specific lines to specific extensions. Not sure if it's me or not but the programming manual is not very helpful.
The customer had a power outage and lost some programming. I suggested they upgrade to a legend r7 processor. But, they are a state run facility so you know how that goes.
Can someone give me the steps I would need to assign the lines?
Thanks,
Brian
Posted By: cvrbob Re: Merlin 2 line assignment - 06/27/11 12:25 PM
Admin T/P to P
Conference twice
Touch Adm Tel, light steady
dial intercom #, or touch auto intercom button ( 2 beep OK )
touch appropriate line button
green light on ( line assigned )
Posted By: BT123 Re: Merlin 2 line assignment - 07/06/11 05:24 AM
Thanks for the info. They still have not sent back to this site. But, it's good to have the info anyway.
Brian
© Sundance Phone System Forums - VOIP & Cloud Phone Help