atcomsystems.ca/forum
Hello, (Tried unsuccessfully to find this topic mentioned)
Recently returned from IP office training and trying to tweek the programming on line appearances. Customer replaced an OLD Panasonic system that changed line status Leds to Red after being handled and is now confused with it remaining Green but blinking at varying cadences. I thought I might be able to assimilate the same line appearances with hunt group assignmnents enabling the lamps to turn Red somehow. They are using 1416s. Has anyone had similar request?
And that "training" was worth every penny too. popcorn

-Hal
Waznt bad, instructor a bit Dbaggy
I think what Hal is trying to say is you can't do what you want to do in this case.
No changing of lights
Hmmmmm.
What is is..........
Apologize for delay, Thankyou for your time, I thought there might be a trick assigning lines to individual trunk groups..Oh well, thanks again,
you can assign lines to trunk groups..that is not the issue. You just cant change the status lights. Those type of functions are just going to be different from system to system. It would open up too many troubleshooting nightmares if it were allowed.
Ah. Thank you.
© Sundance Phone System Forums - VOIP & Cloud Phone Help