I've been installing and servicing Partner systems since the early 90s and I've never seen this one before and I just wondered if anyone else has seen it (and figured out what causes it).
I added a used, defaulted, Partner Messaging R7 to an existing ACS R7.0910 system, programmed ports, recorded AA greeting and showed customer how to use it. The next day they called saying time setting on phones wont hold and they had reset it 2 or 3 times, I had replaced the AAA batteries a week earlier so I know that wasn't the problem. After a few tries it still resets the rime, the weird thing is it keeps resetting from MST to Greenwich Mean Time not to 00/00/00. Does anyone have any idea what's going on??

The system is connected to the outside world through Spectrum Fiber through their equipment that outputs analog lines. That equipment has been working with the Partner for a couple months without any problems.

Jim

Is it possible that the service provider is, all of a sudden, sending a time based upon a different area code? The quickest way to verify would be to connect an SLT and make a set of test calls.

Set the time, then make a call from your cell. Wait for the CID to arrive on the phones, and you will see the time reset itself. Call Spectrum and be prepared to go through several escalations before being resolved

TTT thanks, that's what I thought it probably was, and yeah, convincing Spectrum there may be an issue with their equipment is ..........never fun.
thanks again. Jim