We had a power outage and the system went down. When I tried to reboot the system, it gives me these two codes: E.6 and E.3
Can anyone tell me what this is? When I first start the system it gives me E.6 and after I do a master reset it gives me E.3
I would like to know what the problem is, and how to fix it. Thanks.

P.S. The system is a SX 200 Digital (Mitel)

[This message has been edited by espuela79 (edited February 07, 2005).]

I believe you need to re-program. sorry.

If your database is still there, you might need to re-enter the MOSS sheet.

Or your SYS ID Chip is bad...

If no database...sorry.

Kevin

If you cannot get into the system then the MCC is pooched. I can't find any old documentation that explains each error code and what they mean but the troubleshooting flowchart says if you see those codes to either reseat or replace the MCC.

Hope this helps

E. errors generally refer to disk errors. What version of disks are you running? Did you try to boot from backups? On the new system E.8 will come up if your moss password doesn't match programmed info or if your database is gone.