Is there an add-on module or upgraded software/AUX module that will display CO Caller ID on this system?

which onyx ?

ONYX VS HYBRID 2472 Software version currently in it is:
03.30

there was a caller id /co module and you may also need a Aux card .

I only did one and we never could get it to work , nitsuko engineering got involved and basically the protocol they used was different then what GTE was using so they couldn't get it to work

I never tried another one

What about an NVM Series VM/AA. Does this pass Caller ID info to display sets?

Or any VM?

manual says yes , and you do need the aux card .

Skip,
You a x- TIE tech?

I was.
I have some onyx stuff.
DS and Onyx III

I use to have one of their vans too...bought it for like 200 bucks from the leasing co. They said there were like 5 more other there unaccounted for. You got one?
When Inter-tel bought Convergent/Tie i bailed after two weeks. Just changed the number on the van to my cell. Lasted me a good 4 yrs...and yesh...it was a fully stocked van.

Davetek

no I never worked for TIE per se . Just sold and serviced a lot . GTE sold it in this area so we picked up a lot of service work and we sold it also .

I still have a few onyx VS systmes and a 111 out there chugging along although where trying to get them upgraded

I'm putting a mod 16 in this afternoon :rolleyes:

(customer needs a simple system in a location for 30-45 days and I had one sitting back on the shelf )