atcomsystems.ca/forum
Posted By: dmice Hunt Groups - 05/10/05 09:14 AM
Hello,

I have a question about Hunt Groups. I am using ICS 4.0. I am able to program hunt groups and am able to use them, but when I do, my programming for buttons b01, b02... changes to the hunt groups that I program. Is there a way around this? I would like to have b01 to be DND and if the Hunt group has to be assigned to a button, have it assigned to a different button. Any advice is appreciated.

Thanks
Posted By: BCMguy.com Re: Hunt Groups - 05/10/05 12:12 PM
You have the hunt group configured to appear&ring on the set. Change it to "ring only", and you'll get what you want.

Good Luck!


------------------
BCM Guy
www.BCMguy.com
Learn more about the Nortel Networks Business Communications Manager HERE !
Posted By: dmice Re: Hunt Groups - 05/12/05 07:42 AM
Thank you, but I don't see that option. Where might I find that option?
Posted By: emmitt2727 Re: Hunt Groups - 05/13/05 06:24 AM
YOU HAVE TO GO INTO THE HUNT GROUP, AND THEN LIST THE MEMBERS OF THE GROUP. PRESS THE ENTER KEY TO VIEW EACH MEMBER AND IT SHOULD SAY APPEAR & RING AND THE KEY RIGHT BELOW IT IN THE WINDOW SHOULD SAY CHANGE. PRESS THAT UNTIL IT SAYS RING ONLY.
HOPE THIS HELPS
Posted By: dmice Re: Hunt Groups - 05/13/05 07:07 AM
Thank you so much. I finally got it to work with the wonderful advice provided. Thanks again. This forum's helps beats the poorly written manuals any day.
© Sundance Phone System Forums - VOIP & Cloud Phone Help