atcomsystems.ca/forum
Posted By: redramjim Creating a phantom loop on an Option 11 - 06/29/09 03:34 AM
I've attempted to change an existing analog loop into a phantom loop in LD 17. I am not receiving the prompts that are laid out in the documentation.

REQ: CHG
TYPE CEQU
DDCS
TDS
CONF
DTDT
DLOP
PRI2
APVL
DTI2
SYNM

Any suggestions on how to fill in the other prompts after "TYPE"?
Posted By: mj_wald Re: Creating a phantom loop on an Option 11 - 06/30/09 06:16 AM
I "think" a phantom loop needs to be loop 159
Posted By: Toner Re: Creating a phantom loop on an Option 11 - 06/30/09 08:05 AM
I doubt it has to be 159 on an Option 11, but I do think there's a specific range it needs to fall into. I also highly doubt it can be "changed" from a 500 type to a phantom...

I work with a phantom loop on an 81C that's # 156.
Posted By: mj_wald Re: Creating a phantom loop on an Option 11 - 06/30/09 12:41 PM
I was able to move a 500 from 159.X.X.X to 36.X.X.X

So it should be able to be moved regardless of the TN.
Posted By: Baron-B Re: Creating a phantom loop on an Option 11 - 07/08/09 05:11 PM
The phantom loops are set up in LD 97. You'll have to check the NTP, but I believe the valid loop numbers are 96, 100, 104,... Then the phantom / virtual sets are on "cards" in the 60s and 80s. Make sure you have the NTP books to refer to, or you'll have problems!
© Sundance Phone System Forums - VOIP & Cloud Phone Help