atcomsystems.ca/forum
Posted By: QCIAthol Old MICS 3.1 - 09/13/09 09:46 AM
Trying to help out a school.

I am having a bit of trouble with the night ring scenario. They would like it to ring at the receptionist's desk (101 - they had all the DNs changed to match their old system - it is still the control set - 221)during school hours, and then switch to ring all the phones after hours.

I would like to set this up Auto, and give them a manual button (F871) for overide. I did already set the hours.

The ILG thing is giving me a hard time. Is there a way I can set that up to ring at a group prior to VM (Strtlk 1.7)?

Do all the sets need to "Appear & Ring", or does the ILG overide that? I set them up with appear only because to have the classrooms ring during the day would definately get me a detention.

Any suggestions?
Posted By: MooreTel Re: Old MICS 3.1 - 09/13/09 10:46 AM
Either you'll get detention, or they're "SOL". For the phone to ring at night, it MUST ring during the day as well, unless someone's found a solution.
Posted By: NTlayoff Re: Old MICS 3.1 - 09/13/09 07:30 PM
Is that one issue or TWO ?? ( night / ILG )

For your night ring, get rid of the ILG.
You make it ring on 101 - then your night ringing service in AUTO mode it will kick in and ring the phones you want.
Posted By: QCIAthol Re: Old MICS 3.1 - 09/13/09 08:38 PM
OK, I'll lose the ILG

How do I determine the phones I want to ring?

In daytime, it only rings at 101, but at night I'd like it to ring at several (or all) phones.

Can do?
Posted By: vad60 Re: Old MICS 3.1 - 09/14/09 04:47 AM
Control sets for the Ring Group has to include all phones you wish to ring at Night mode.
Posted By: telemarv Re: Old MICS 3.1 - 09/14/09 05:12 AM
Quote
Originally posted by MooreTel:
Either you'll get detention, or they're "SOL". For the phone to ring at night, it MUST ring during the day as well, unless someone's found a solution.
The only way to really control ringing paterns is not use A&R at all, but to set ring groups day, night, lunch etc.
Posted By: NTlayoff Re: Old MICS 3.1 - 09/14/09 05:54 AM
Quote
Originally posted by QCIAthol:
............How do I determine the phones I want to ring?
In daytime, it only rings at 101, but at night I'd like it to ring at several (or all) phones.
Can do?
Daytime you have just the one phone set at RING or Appear/RING.
Go into Services Ringing Group.
Look under Night.
Services ON
Trunk Ans YES
Line settings: Select the line(s) you want into the RING Group you want to set up.

TIP:
It is easier to set up ring group #5 (or higher).
Too many Default settings for Ring Group 1 etc to "unprogram".
© Sundance Phone System Forums - VOIP & Cloud Phone Help