Can someone tell me what overlay to use to remove an E&M trunk card from an Option 11?

I tried doing it in 20 and when I enter:
OUT
CARDMLT
TN
It comes back with a SCH error saying I am in the wrong overlay. Doesn't work in LD 14 either. I need to remove the card to install a digital line card.

Remove all trunk ports. Replace E&M card with with digital board. Initialize and program away.

Trunks are built and removed via LD 14, whether they are analog or digital. I assume this is a TIE trunk, since the card is E&M. Print a TNB of one of the trunk TN's to see what type it is, then access LD 14 and out it.

REQ: OUT
TYPE: TIE or other trunk type like COT, DID etc..
TN: TN of the trunk to be removed

Worked like a charm.

Thanks guys.