Grateful to hear from anyone who has any knowledge of setting up an ISDN Primary Rate Interface Link. I have been able to set up a link but have a problem when calling into the KXTD1232 in that I can't hear any ringing tones. Outgoing calls are fine.

which card are you using? the 382, 384 or 386.
You have mail.
Had to send it to the "someone" address?
That's all I could find for your contact Info. on your web site.

[This message has been edited by MrGemini (edited January 05, 2005).]

Sir Gemini,
I think he's talking about PRI, not BRI
The Basic Rate Interface are the 2/4/6 channel modules which are pretty much a dead duck here in the USA. I've got a couple of each of the Panasonic BRI cards sitting here that I'd just about *give* away

-Joe
https://www.usedpanasonicphones.com

i may take those joe. still alive here in houston. company south of town charges 40 for a BRI and 55 per POTS. best part is you get a digital line pretty cheap.

shoot me an email on a price.

as far as the PRI issue PTSHL1ZZ is having, probably need more info. are you using DIDs? did you set up the routing properly? lot of factors in the PRIs. probably easier to help you offline so send me an email.

I hear ya Joe, he may have a T1 with PRI but he did say ISDN.
We're all going to need more Info. and his e mail bounced.

If any of you guys have any answers on this subject please e mail me it because I am going to try an install just like this and any info would be helpful

Thanks very much
MDRMDR

R, you have mail.

dont know if you use crc error check in the states but we get same effect in ireland if crc is not set to the same from provider as set on the system.would like to know if line are set as loop co or direct co (ie )if set as direct co direct co maby only 12 lines programed but call arriving on higher line then system wont ring...just a tought...

Can anyone tell me what the is the difference between NI1 and NI2?????