Hello,

I recently replaced a Panasonic 624 with an 824 I am having trouble receiving cid info on SLT sets, it is working fine using PT sets, it is just not working on SLT. I am sure it is just a programming error on my end, I just cannot seem to find where. any help would be greatly appreciated

thanks

Are you using the windows programming?
You do need to enable it.
9.9.2
Page 222 of the programming manual.
MrG

Thanks,
I will give it a shot, I have not been able to use windows programming, laptop crashed, literally, crashed to the floor, just replaced it, now all I need to do is find the box of cd's with all my software )