D1232 with TVS80 vm. Auto Attendant picks up immediately without any of the phones ringing first. When someone calls our phone number, it always takes 2 rings before the TVS80 picks up. Any reason why it doesn't pick up on the first like most other Pana VMs? Or is there a setting somewhere I need to change?
Thank you, Thomas.

If you are using caller ID the system will not ring anything until after the 1st ring.
There is a delay answer setting for the TVS but it defaults to 0.
There is also WCID command in the utility area to tell the VM how long to wait for CID from the PBX after the ring, if in use may be set to 5 sec.
If you don't need CID sent to V Mail set this to 0.

pretty sure the 80 didn't have callerid
built in.

Got it figured out, thanks for the help guys.