[TD 100] Busy out for Analogue CO - 06/14/07 04:58 AM
Hello,
I need to enable the Busy Out for Analogue CO option on my TD-100. But in my environment the CO lines are connected/disconnected very often and I cannot force my customer to re-enable the line (with *785+00X code) manually. In the manual is stated (1.5.4.6):
"When a trunk is in busy-out status, loop current detection is performed at fixed intervals, returning the trunk to in-service status once a loop current is detected."
It is possible to configure this timer?
If so, how?
Thank you very much
I need to enable the Busy Out for Analogue CO option on my TD-100. But in my environment the CO lines are connected/disconnected very often and I cannot force my customer to re-enable the line (with *785+00X code) manually. In the manual is stated (1.5.4.6):
"When a trunk is in busy-out status, loop current detection is performed at fixed intervals, returning the trunk to in-service status once a loop current is detected."
It is possible to configure this timer?
If so, how?
Thank you very much