Dear,

Panasonic TES824 conference call is not working ,

procedure

from single line phone dial Line 81 to select line 1 + desired No + Flash
dial 82 to select Line 2 + desired No. + Flash 3
suppose to be connect all 3 parties but it does not one party goes on hold then again if press flash other party goes on hold (From Proprietary set its working but from single line phone not working this feature)

Any one know this issue

tariq

Instead of specifying Line 1 & 2 (81 / 82) ....try just idle line grab > dial 9 ...number.... tell first caller to hold.... press flash> 9 > number ...then when second caller is on press flash>3 .
This should do it...there could be some glitch with specifying a line and doing conf on a SLT.
(Panasonic had glitch on call-waiting lines and flash on KX-TD....never fixed either...)

No dear i tested but same result ,not able to make conference call via SLT.

Can you transfer a call from the slt ? If the flash timer doesn’t match on the phone and the system the call will either get dropped or not go on hold and the call will stsy on the phone