Originally posted by jfreeman:
From what I remember when I worked on one of those at a small hotel you can pull the trunk card out and there will be a little toggle switch on the board that switches the card from G to L. Switch it to L for loop start. This may have been a feature on the old sx200. Good luck.
Can anyone verify this. I plan on going over there after work tonight, I have some networking of pc's to do, so I can pull the card and look then.
Pull the card on this system=
1) Power down
2) Disconnect 25 pair
3) Use supplied tool to pull card
4) Switch from G to L
5) Reverse for install and power back on.
