If you are setting up a IP phone remotely here's the procedure from Toni:

at the prompt "set(*) reboot(#)"

press *
dial password (NO PASSWORDS PLEASE)
press *
press # to change to remote system

Use the volume up/down key to change IP settings

The phones MAC address must be entered in pgm 386

Scroll to MFIM address:

Enter the address of the voib card locate in pgm 340

Press hold/save(I think)

Press speaker to complete. The phone should reboot and connect.

if you don't enter the MAC address of the phone it won't work. You also don't need a password for an IP set, only a soft phone.

Also: You can only FWD B/NA to VM after you've recorded a personal message.

Also: if you set up a hunt group with IP phones and soft phones the system will ring them in station order (ie 109 then 110) even if you program it in an alternate order(programmed as 110, then 109). Don't know if it's the same with TDM hunt groups.

Anybody know how to see another phones message light or get an indication of messages? Can it be done in a Station Group?

Anybody figure out how to stop the DND/FWD light flashing when the phones forwarded to VM?

***Edited due to violation of terms of service by posting technician/installer password in public forum***