Hi peeps.

I have a small problem I wonder if anyone can help.

I have a DCS 816 with 3 analogue lines.

My problem is I am trying to setup call forward to a mobile.
Which I have done using fwd5 key and night service mode key.
Fwd5 is set to my mobile and night service is set to dial my ext 206 only.

Now my problem is it works the first time then not the second time when I try a few seconds later.

When I dial the trunks 701, 702, 703. 702 is clear, 701 and 703 are busy and do not release until the co – co line disconnect times out.

I have reduced the co – co line disconnect time to 5 mins but obviously after 5 mins the call fwd disconnects the fwd5 to mobile call.

When the co – co disconnect timer expires then the system will fwd5 another call.

I am wondering if there is a problem with the system not disconnecting the line after the fwd5 parties call is finished.

Any help would be appreciated.

John.