I have a DXP ( 14A SW ) and cannot get caller id info to show on the sets. I have connected to cid08 with laptop and procomm and receive info on terminal screen. I have set the lines on DXP for caller id. The sets are programmed to ring. I have the absorb time set to 5 secs. Set the baud rate on the DXP to 9600 N 8 1. I am using DXP document IMI89-140 to make the cable from the cid08 to the DXP. Is this connection different from the programming adapter? In the manual it shows pins 7 and 8 are shorted. Pin 2 goes to the receive on the DXP and pin 5 is signal ground. My programming adapter does not use any shorts just pins 2,3 & 5. Any help would be most appreciated.