Or, more detail:
TRSF 800
ENTER PASSWORD
1 TO ENABLE
SPEAKER
724
USE VOLUME UP/DOWN TO DISPLAY:
STN NUM PLAN:C1
SX-P01:201->
PRESS RIGHT SOFTKEY TO MOVE to Cabinet Selection, press Softkey again to Change to Slot, Press Softkey again to move to Port, Press Again to move to the new setting. Enter new ext #, press Left softkey to change back to port, if the new # you enter conflicts with another, you will then have to press 1 to override it.
Since, I noticed you had 0xxx you may want to go back into feature codes, and reset oper back to 0
Hit SPKR to exit , press 800, hit 0 to disable programming, then hit TRSF to exit tech mode.
[This message has been edited by Wkstill (edited February 22, 2005).]
