Hello Everyone,
So, I have a valcom v-1030c that was working fine before I moved it. The volume is set to the proper level (very low not loud at all) and now that I have moved it, it sounds like the speaker inside of it has been blown. The only change that has been made is i have it on a seperate valcom power supply. (VP-624) I attached it to the page control power supply (VP-624 as well) and it works fine on the one that is powering the page control. I have also tried this horn on a analog SLT (with no page control attached) and it works fine when you attach it to the power supply powering the page control but when you put it on the extra power supply i have it doesn't work. So I'm guessing that it is the power supply, but has any one else ever had this problem before or run into something simmilar?

Thanks,
Daniel