Hello All,
I have installed a ton of these over the past years. However, I have not serviced this DK 424 with an IVP8-R2 in years. I have one issue....I reach the AA and dial the station and the call loops back to the main greeting.
I tried. Intercom #601, #656, Intercom # 657, Intercom #604, wiping out the system and completing a plug and play, reprogramming the system, changed system type to '424', I know in the LVMU if you dont change the SMDI port it loops. I did not change that on this vm. I remember way back in the DK days that there was a timer, if i recall, the telephone system may be pulling it back. Not sure, any help would be appreciated. NOTE: The only way the appropriate mailboxes answers if if DND is enabled.
Thanks,
DMW
Last edited by DMW; 11/30/17 08:44 PM.
