Greetings All ~

I seem to be having some problems getting remote messaging to work correctly.

I have setup a mailbox with a Cascade level 1 to call my digital pager (outside line) and leave "MN" (mailbox number, message count)

Unfortunately I never receive the page. While watching the AvdapMon I see the following error:

VMOUT1]Calling (xXXXX,XXXXXXX#,mbXXXX, 6 rings)
VMOUT1]Result=(EV_toll_restricted)
VMOUT1]Call number result = EV_toll_restricted
VMOUT1 Out]Next notification for mbXXXX in 5 minutes
DISPATCH]Terminating VMOUT1
NTFY]Remote messaging setup failure for mbXXXX

Note: XXXX represent valid numbers.

I am not sure what I have done here, I can tell you that I have had remote messaging working in the past; however that was a long time ago, and I have since made major changes to the db.

Any idea what could be causing this, or where I can look?

Regards,
jim®