Hey Guys, so I've been in a situation the past two days. Spectrum setup a Session Boarder Controller with an IP with no registration.
When I follow the guides I'm getting no where. I set-up the system per NTAC, sent me how to setup as non-registered
What I'm getting is outbound times out after like 30 seconds with no dial tone, ends up giving me a busy signal. Inbound, the caller ID shows and the phone rings on the Phantom, but on the other side (cell phone) it gives a call cannot be completed error. If you pick up the handset while it's ringing it is just silence then disconnects. Currently I have the Session Boarder Controller going to the Customers 24 Port Switch, the NEC SL2100 going to the same switch. Any help would be appreciated as NEC looked at my database and says its good. With Spectrum, we tried doing a ip with registration, and went back to IP without registration.
