|
|
Joined: May 2008
Posts: 7
Member
|
OP
Member
Joined: May 2008
Posts: 7 |
No - not a overlay problem
Here is what is going on --
ARS DIGIT ANALYSIS TABLE Location: all Percent Full: 17
Dialed Total Route Call Node ANI String Min Max Pattern Type Num Reqd 12 11 11 p5 fnpa n 13 11 11 p5 fnpa n 14 11 11 p5 fnpa n 15 11 11 p5 fnpa n 16 11 11 p5 fnpa n 17 11 11 p5 fnpa n 18 11 11 p5 fnpa n 19 11 11 p5 fnpa n 1900 11 11 deny fnpa n 1976 11 11 deny fnpa n 1xxx555 11 11 deny fnpa n 1xxx976 11 11 deny fnpa n 2 7 7 p8 hnpa n 206 10 10 p5 fnpa n 211 3 3 p2 svcl n
list ars route-chosen 12064441212
ARS ROUTE CHOSEN REPORT
Location: 1 Partitioned Group Number: 1
Dialed Total Route Call Node String Min Max Pattern Type Number Location
4 7 7 p8 hnpa all
If i dial 1206 number - somehow it is stripping the 1206 and in this case since it was 1206--4 it sends the call out the 7 digit local call pattern for 4 -
list trace station 8880 Page 1
LIST TRACE
time data
11:11:07 tone-receiver 01B0105 cid 0x31 11:11:07 active station 8880 cid 0x31 11:11:13 dial 912064444444 11:11:13 term trunk-group 6 cid 0x31 11:11:13 dial 912064444444 11:11:13 route-pattern 1 preference 1 cid 0x31 11:11:13 seize trunk-group 6 member 26 cid 0x31 11:11:13 Setup digits 4444444 11:11:13 Calling Number & Name NO-CPNumber NO-CPName 11:11:13 Proceed trunk-group 6 member 26 cid 0x31 11:11:17 idle station 8880 cid 0x31
|
|
|
Forums84
Topics94,296
Posts638,846
Members49,769
|
Most Online5,661 May 23rd, 2018
|
|
1 members (justbill),
166
guests, and
271
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|