I need a couple of pointers on getting my number to show on caller ID. I have experience on Inter-tel and others but not much on Avaya. I'm working on a Magix 4.0 v7.0 with a 100D/CSU/DSU-U card in slot 05. The Verizon smart jack says T1. (I haven't heard back from them to verify that.)I believe the office is a DMS-100. I found in programming with WinSPM a place to put the "number to be seen" in the PRI section. I put my number there but it doesn't show-up. Am I anywhere close? Any help will be appreciated.--Brent