atcomsystems.ca/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems New Guy with easy question

The pocket reference guide only says to exit by pressing the release key on the console, is this the "save" function. I can't find a "save" funciton in this guide.

So these are the steps to get this from GS to LS trunks.

1) Log into the system with hopefully the default access code
2) go to command 565 check register 1 bit i to make sure its turned on first
3) if turned on go to register 2 (not quite sure how to do this) and bit g and change the 1 to a 0 then save.

Will the system need rebooted to make this happen or should the programming take automatically?

No reboot necessary. To get to register 2 type a 2 when in register 1 with the first 1 (bit a) blinking.

Ok, I am here right now, I can get in and get to register 2, how do I get down to the g location, when I hit next it takes me to the next register. I am unable to locate this info anywhere on how to move to different locations.

Its in GS mode and I could change it if I can get to bit g

Thanks

When I try to follow the bits over, ie, 20001101, as soon I put in a 0 after the 2 I am getting an e11 write protected data on the display.

Maybe I am in read only mode, if so the default sec code doesn't work on this console.

Ok, I think I got this figured out, I can get in with the default user security code and view the commands but can't do anything with them. Anyone know how to reset the system security code without reloading the system defaults? I see some reset switches, do they do anything to help out with that?

This systems looks very simplistic once I am into it, maybe I am fooling myself. :toothy: :toothy:

Make sure the bottom switch in the red switchbank on the side of the phone system to the right is set to open hten it will accept data changes.

Private message has been sent.

Thanks for everyone's help, I now have tone on the trunks thanks to this forum and especially westerntelephone.

I think it should be set to closed at least on my system it is. This Forum string helped me out. thanks westerntelephone