sundance-communications.com/forum Forums TDM Business Telephone Systems Nortel Telephones & Systems Meridian 1

What is feature code on sets to identify extension number. Thanks for the help guys.

There is none that I am aware of. Call a display phone from that set and what the ext number is in the display.

You can use Feature "*0", the button inquiry. If you press the intercom button, it will display the extension.

That depends on the word "Meridian". For most techs that know Nortel, Meridian refers to the Option-11 to 81 PBX systems and the bigger systems. Even though the older Norstar phones used to have Meridian label on them, (now removed because of the confusion) the Norstar's are NOT Meridians. The topic says Meridian. In the true sense "Rather Be Fishing" is Correct. But if in the confusion, if Chuck was wrongly calling the Norstar a Meridian, then NCSUFan06 would be correct. I hope that is as clear as MUD.

You are correct, the system is Option 11. The phones do not have a Feature Button on them. Where do I go from here. Thank you again.

If you want to see the programming of each button you need to access your switch, go into LD 20 prt the DN, then prt the TN. I am assuming the RLS of that switch is above RLS 16. If it is not you have to do some of your prt commands in LD 22.

Do what Rather Be Fishing said.
Call a phone with a display and it should show you what extension you are calling from.
The other way is the hard way. Find what jack in the wall it is plugged into. Find the cross-cut back to a port on the Option. Then print out that port and it will tell you the extension.