atcomsystems.ca/forum Forums TDM Business Telephone Systems NEC Telephones & Systems E1 Qsig for SV8100

Does anyone have a cheat sheet on how to set up the SV8100 using E1 Qsig?

Do SV8100 have Qsig feature ? I think it does not support

I pretty sure it does. I have set this up on the UX5000 and pretty much have to set it up like tie lines with the F-Route tables.

It does have Qsig license 0013 but I thought it was only on PRIs or is down my way..

QSIG rides PTP T1's that you use as PRI.

Yes in AUS / NZ Q sig is supported on PRI card i dont know if you need the licence though (ill have a look at some documents i was sent)

P.S. Hope your all ok PaulW over there in NZ

I cant send Ming a private message?
can i just post the info here?

first some of the draw backs
(this was an SV8100 to an erricson)
The SV8100 could only be the slave.
you set up the trunks as DID and use conversion tables to route the calls.
the outgoing caller id per station was used to forward the caller id to the erricson which meant you couldnt have normal DID trunks on the SV8100 that would send xtn level caller id.

The setup
im gonna assume you know the basics of the system!
pretty sure you just jumper PRI straight to the other systems interface card but jumper send/recive as applicable.
set the trunks to their own trunk group
Use F-route to forward calls to the other systems extensions, and make sure you set 44-05-09 to other systems xtn length and 44-05-03 add any digits you need
10-03 "PRT card"
10-03-01 T-point
10-03-03 active
10-03-05 active
10-03-08 EN Block
10-03-10 Slave
10-03-17 ISDN Ringback
10-03-22 Qsig

i also remember maybe changing 22-09-04 to suit

Hope this all helps