|
|
Joined: Oct 2007
Posts: 81
Member
|
OP
Member
Joined: Oct 2007
Posts: 81 |
Hello!
I updated tva50 to 3.15 awhile ago and just today notices that #8 transfer to ext. does not work. I dial that command and nothing happens.
Do you know what may have been the reason for that?
When I go back to 3.1 it works again, then I go back to 3.15, does not work.
Perhaps I enabled some feature that prevents using #8 command in 3.15?
Very much thank you in advance.
TVA-50, TA-824 with 16 ext, 6 lines and a LAN card
|
|
|
|
|
Joined: Jan 2007
Posts: 1,217
Member
|
|
Member
Joined: Jan 2007
Posts: 1,217 |
That feature is disabled after upgrading to 3.15, you have to re-enable it in the command prompts. You can find the commands in the TVA Command Lines Programming Tech Note.
Aaron
|
|
|
|
|
Joined: Oct 2007
Posts: 81
Member
|
|
OP
Member
Joined: Oct 2007
Posts: 81 |
Aron, thank you so much, but what is it called? There are many of them there
thx
Last edited by BalkyNY; 04/13/17 02:01 AM.
TVA-50, TA-824 with 16 ext, 6 lines and a LAN card
|
|
|
|
|
Joined: Oct 2007
Posts: 81
Member
|
|
OP
Member
Joined: Oct 2007
Posts: 81 |
Never mind, OPTN 21,1 this is it. Thank you 
TVA-50, TA-824 with 16 ext, 6 lines and a LAN card
|
|
|
|
|
Joined: Jan 2007
Posts: 1,217
Member
|
|
Member
Joined: Jan 2007
Posts: 1,217 |
Aaron
|
|
|
|
Forums84
Topics93,879
Posts637,000
Members49,673
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (iatech3800),
31
guests, and
12
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
