CAN ANY ONE HELP WITH SMDR OUTPUT FOR 50SI VER 1.6. THERE IS A MISC1 CARD IN THE SYSTEM. DO I NEED AN OPTIONAL CARD OR CAN I GET IT FROM THE COMS ON THE MIS CARD? SO FAR NO LUCK.

First... please turn off your CAPS lock, there is no need to shout.

I don't have a lot of experience on the older systems, but I believe you need a Serial Interface Module (SIM) to get SMDR to work. The SIM connects to any DLI port.

Marc,
SIM only works on the DCS, on the 50si you need a MISC 1 for smdr.
There are Different pin-outs for PC or a printer


Double check you Comm settings to assign each com port to either printer or PC

Edit to remove technical information, please post technical information in the installer forum only.

I am responding to this in the Installer forum

sorry about that.. was not able to post in installers forum yet. will PM that info in the future.