hey everybody good morning from SoCal. So I have a 50 that is running off analog trunks. It has a SIP card in it as well because the site was to install a better internet and they finally did.
I can convert to SIP ok but i have two questions I'm hoping somebody can clear up.
1. Right now there is a corp. # going to one ext. as a second tenant- Not sure why my tech set it up that way. Do i duplicate that in F224 as a DID to an ext (it will be a SIP #. 1 of 2 numbers)
2. Has anybody used the Netgear FV5318G for SIP-this is what they have now?What was your experience in using this with SIP.

What DNIS digits are being sent? That what determines where to put that number. If there are no DNIS digits, then you need to segregate the SIP Trunk and send it to the station it's supposed to ring.

That Netgear is a firewall as well as a gigabit switch. It should work just fine providing it's programmed correctly.

Rcaman

No DNIS Digits so do I use F224 to do this segregation?

thanks for the info on the router

F2141. Program it like you would F211.

Rcaman