What does one normally see on the HDMI port when you boot up a UC Module V2? Is it Grub and the Linux bootup sequence like you see with the V1? We have a dead module that just loops at "Initializing" in SSA but get no signal whatsoever on the HDMI port.

Well, it definitely seems the UCMv2 is dead. Here are the steps we took to recover (because we didn't have a spare UCMv2 available):

1. Pulled m-SATA drive and installed in a laptop
2. Booted laptop to Linux CLI
3. Changed eth0 to IP we could use (/etc/sysconfig/networking-config scripts)
4. Connected via Voicemail Pro Client, performed an immediate backup
5. Moved backup to a UCMv1 and restored
6. Installed UCMv1 in IPO
7. Bob's you're uncle!