atcomsystems.ca/forum
Posted By: Buttinset Avaya Partner ACS 308 Loudspkr paging troubles - 02/28/24 12:46 AM
A Partner 308 gives users what sounds like an error tone when they try to access Loudspeaker Page by using I70. That is, by pressing Intercom 70 or a button programmed as I70. Just to be clear, all stations get Intercom dial tone when going off hook. The Valcom paging unit is plugged into the Partner's Page jack. Background music over the loudspeaker system works fine. This all worked fine until the system defaulted following a three hour power outage (when it was -43F outside).

Any suggestions?
Posted By: mongo5150 Re: Avaya Partner ACS 308 Loudspkr paging troubles - 02/28/24 02:32 PM
I would try removing the page equipment and put butset on t/r of page port. Does it work? Been so long since have troubleshooted this. Hopefully the human encyclopedia (TTT) will see this.
Posted By: Touch Tone Tommy Re: Avaya Partner ACS 308 Loudspkr paging troubles - 02/28/24 04:05 PM
Matt is correct, the Valcom equipment could be loading the paging port, so the Partner sees it as already in use when you dial I70. Disconnect the Valcom and dial it again, even without a butt set connected it should activate the port.
Posted By: Buttinset Re: Avaya Partner ACS 308 Loudspkr paging troubles - 02/28/24 04:30 PM
Thanks for the suggestion. I have disconnected the line cord connecting the Valcom paging unit to the Page jack of the Partner and no change. I've also tried disconnecting the music input to the Valcom. I still get the error/restricted-access/warble tone when trying Intercom 70. I am at witts end and am about ready to default the thing and start all over. It is a pretty simple/small system. Any other words of wisdom? The customer is a grocery store and need the paging oftern.
Posted By: dexman Re: Avaya Partner ACS 308 Loudspkr paging troubles - 02/28/24 08:21 PM
Agree with the default and start from scratch. Does the system have a backup PCMCIA card installed? If so and it was backed-up before the power outage, try a system restore before going the system default route. smile
Posted By: Buttinset Re: Avaya Partner ACS 308 Loudspkr paging troubles - 02/29/24 02:34 PM
Success. Thanks for all of the suggestions. It might have helped if I hadn't thought that the system was a 308 when it is a 509. So, looking in the wrong manual didn't help.
I did end up defaulting it (there was no PCMCIA card) and starting from scratch. While programming and pressing Next Procedure I noticed LOUDSPEAKER PAGING LINE (#617 ?) and assigned Line 5. Then I programmed "Page" buttons as I70 and moved the line cord from PAGE JACK to LINE 5. Test pages worked fine. I still don't know why using the Page Jack didn't work, but TAH DAH!
Thanks again.
© Sundance Business VOIP Telephone Help