Printer port on ICP controller went bad. I'm going to run smdr to the console rs232 port, then to the DB9 on the remote port of the Tel-Electronics unit. Do I use a straight-through DB25 to DB9 serial cable? Other than forms 12, cos, and 34 what other trouble am I looking at?
Thanks in advance.
I dont believe SMDR is supported off the Console you will have to go with a Ipocket IP to Seriel device
Well I know you could do it with the ML/EL. Wonder why it wouldn't work on the ICP?
I may be wrong but I was under the impression you could not. I just check the 200 ICP 4.0 DOc's and they say you can. I sent you a PM on the data from the DOC's
Let me know if it works
Did a little more research- It looks like you can but I believe you have to have the power supply for the console.
Power adapter ordered, thanks!