|
Joined: May 2005
Posts: 1,005
Member
|
OP
Member
Joined: May 2005
Posts: 1,005 |
Printer port on ICP controller went bad. I'm going to run smdr to the console rs232 port, then to the DB9 on the remote port of the Tel-Electronics unit. Do I use a straight-through DB25 to DB9 serial cable? Other than forms 12, cos, and 34 what other trouble am I looking at?
Thanks in advance.
|
|
|
|
Joined: May 2005
Posts: 370
Member
|
Member
Joined: May 2005
Posts: 370 |
I dont believe SMDR is supported off the Console you will have to go with a Ipocket IP to Seriel device
Alex Kroger Pinnacle Communications Corp Mitel/Hitachi Nationwide Hospitality Provider
|
|
|
|
Joined: May 2005
Posts: 1,005
Member
|
OP
Member
Joined: May 2005
Posts: 1,005 |
Well I know you could do it with the ML/EL. Wonder why it wouldn't work on the ICP?
|
|
|
|
Joined: May 2005
Posts: 370
Member
|
Member
Joined: May 2005
Posts: 370 |
I may be wrong but I was under the impression you could not. I just check the 200 ICP 4.0 DOc's and they say you can. I sent you a PM on the data from the DOC's
Let me know if it works
Alex Kroger Pinnacle Communications Corp Mitel/Hitachi Nationwide Hospitality Provider
|
|
|
|
Joined: May 2005
Posts: 370
Member
|
Member
Joined: May 2005
Posts: 370 |
Did a little more research- It looks like you can but I believe you have to have the power supply for the console.
Alex Kroger Pinnacle Communications Corp Mitel/Hitachi Nationwide Hospitality Provider
|
|
|
|
Joined: May 2005
Posts: 1,005
Member
|
OP
Member
Joined: May 2005
Posts: 1,005 |
Power adapter ordered, thanks!
|
|
|
Forums84
Topics93,884
Posts637,026
Members49,676
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
73
guests, and
15
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|