Added a new peripheral bay. Programming shows ok in config, but doesn't show installed cards. Form 53 ok.
form 1, did you configure the bay type there?
form 4 option 133, do you have the proper amount of TDM bays there?
Is it a BCC III? Those are notorious for requiring a long time to boot, and a shutdown while booting can ruin them.
Also, check licenses and purchased options (form 4).
Licenses, options, tdm's ok, will check node type in form 01.
Turns out they sent a T-1 module instead of a CIM module. Jeez..
when you install the CIM module the BCCIII can take up to 25 minutes to boot