I have a MICS hooked up to a Call Pilot 150 with 6 incoming lines. All six lines are in a hunt group from telco. When 5 out of the 6 lines are being used the 6th caller receives a busy? Any ideas? Thanks

Does your fifth line roll over to linee six?

Check with your telco

Pick up line 5 and dial line 5,see if line 6 starts ringing .

Are you sure that Line 6 is not the fax or modem line somewhere and therefore not in the cascade?

Put lines 1 thru 5 on hold. From your cell phone, call the main published number. It should ring in on line 6. If not, then the telco hunt group isn't configured right.

Jim